Meliconi Control TV Digital - Manual (Page 4)

8 9
CHECK
Check that the other buttons correspond to the functions of the original remote control; if not, it is likely that the code
found is incorrect, but is used for a very similar device. In that case, repeat the procedure from point 2.
If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN USE
procedure and make a note of it inside the battery cover.
NOTE: During the search the indicator stops flashing and the remote control exits the programming mode in the
following cases:
• if for 12 seconds the button indicated is not pressed or if another button is pressed
• if the list of codes to find is terminated. If this happens, go to the www.meliconi.com/guida website.
DISPLAY CODE IN USE
If you set up the remote control using the MANUAL SEARCH
procedure, obtain and make a note of the code in use as follows:
1. Press and hold down the ON / OFF and MUTE buttons
simultaneously for 6 seconds.
2. Release the button. The indicator light will flash. Press
the TV / radio button for an instant .
3. After a pause of several seconds, the indicator light pro-
duces four sets of flashes, spaced out, corresponding to
the code to be obtained. Count the number of flashes.
Each set of flashes corresponds to one figure in the
code. Ten flashes correspond to the figure 0.
4. Make a note of the code obtained on the label on the in-
side of the battery cover. You may need it in future.
Code obtained = 1306
2. Press and hold down the ON / OFF and MUTE buttons
on the Meliconi remote simultaneously for 6 seconds
3. Release the buttons. The indicator light will flash.
Point the remote control at the TV and press the ON /
OFF. button. If the TV does NOT switch off, press the
same button again slowly (it may be necessary to press
the button several times).
4. When the TV responds correctly, press OK. Three long
flashes indicate that the operation has been carried out
correctly.
6 SEC. and
6 SEC. and