Meliconi Control TV Digital - Manual (Page 3)

8 9
(only to be performed if the specific code could not be found)
1. Turn on the TV you wish to command and select a
programme.
SETTING CODES USING A MANUAL SEARCH
1B, TV, PHILIPS,
32PFL3614 EXAMPLE:
1B, TV, PHILIPS, 32PFL3614
For those who do not have access to the Internet, MELICONI now provides the opportunity to receive the codes to be set
on the remote control directly on their mobile phones.
SETTING BY MOBILE PHONE
(this service is free; the only expense is due to sending the SMS, according to the fees applied by the mobile service carrier)
Write an SMS including the following: 1B, TV, Brand, Model
set the brand of the device to be controlled
set the model of the device to be controlled, usually found on a
label at the back of the device (if the model is unknown, do not write
anything after the brand)
Fixed text that must always be entered
WARNING - separate data with a comma, and be as precise as possible so that the information system can search
for data and answer correctly.
Send the SMS to 0039 345 7518893 and wait for a reply by SMS.
After receiving the code list by SMS, set the first code on the remote control as described in the ENTERING THE CODE
DIRECTLY procedure.
Stand in front of the device already turned on with the MELICONI remote control and press the ON/OFF button. If the
device does NOT turn off, try to set the next code on the SMS list on the remote control. Repeat the operation until
the device responds. When the device responds, confirm that the other buttons are also operating correctly. If so, the
remote control is ready to use. Otherwise, an inaccurate code, used for a very similar device, is being entered; ignore
the SMS list and see paragraph MANUAL SEARCH to identify a more suitable code.
NOTE: If no SMS is received on the mobile phone or if the message ERROR / NO CODE is displayed,
the system was not able to process the data; do not attempt to send it again and only use the MANUAL SEARCH to set
the code.