Meliconi Control TV Digital User Manual

Page 2

INSERTING THE BATTERIES

Before using the remote control, insert the batteries and programme it.

Do not leave flat batteries inserted,

as liquid may leak and damage the remote control

The

Control TV Digital remote control is a universal remote with a memory containing data regarding numerous devices

produced by different brands on the market.

Each original device has a specific code which must be used to set up the remote control.

So to use the

Control TV Digital it is essential to insert the specific code of the TV you wish to command.

Use one of the following methods to identify the correct code and set it in your remote control:
A) - INTERNET (recommended)

B) - MOBILE PHONE (SMS)

C) - MANUAL SEARCH

SETTING THE CODE

If you have an Internet connection available, follow the on-line guide on the

www.meliconi.com/guida

website to identify

the specific code for the TV you wish to command. Then set the codes manually in your MELICONI remote control as

described below:

SETTING CODES USING INTERNET

The remote control requires 2 new 1.5V alkaline

AAA/LR03 batteries. Insert them

as illustrated.

Try pressing a number button and check that the red light remains lit continuously

until you release the button. If the light flashes, the batteries inserted are not charged

and are about to go flat, therefore you must substitute them.

If they do not appear, repeat the procedure

1. Press and hold down the ON / OFF and MUTE buttons on

the Meliconi remote simultaneously for 6 seconds.

2. Release the buttons. The indicator light flashes.

Immediately enter the specific code found previously

(e.g. 1306).

3. Three long flashes indicate a correct setting.

6 SEC.

and