Marshall Electronics CV350-5X - Manual (Page 15)

15
1080 HD-SDI 5X Camera
Select IMAGE CONTROL using the UP or DOWN button.
You can select 3D-DNR, MOTION, SHADING, and GAMMA using the UP or DOWN button.
IMAGE CONTROL
3D-DNR, MOTION
SHADING, GAMMA
3D-DNR: This feature will reduce the video noise caused by movement at
low ambient light.
IMAGE CONTROL
DAY/NIGHT EXT
COLOR IIIIIIIIIIIIIIIII 10
SHARPNESS IIIIIIIIIIIIIIIII 10
IMAGE FLIP OFF
DEFOG OFF
3D-DNR LOW
MOTION OFF
SHADING OFF
GAMMA STANDARD
RESOLUTION HD1080i60/NTSC
RETURN
MOTION
DET. SIZE IIIIIIIIIIIIIII 03
SENSITIVITY IIIIIIIIIIIIIII 10
MASK ACTIVE ON
WIDTH IIIIIIIIIIIIIII 26
HEIGHT IIIIIIIIIIIIIII 33
MOVE HOR IIIIIIIIIIIIIII 01
MOVE VER IIIIIIIIIIIIIII 01
RETURN
Select the 3D-DNR level from OFF, LOW, MIDDLE, and HIGH using the LEFT or RIGHT button.
MOTION: This feature will observe the object movement by motion zone and sensit-
ivity that are pre-set with sub menu. The motion detection signal can be relayed out
with MD OUT port.
DET. SIZE: Select the size of the object that is motion detected from 00 ~ 04.
SENSITIVITY: Select the motion detection size from 00 ~ 20.
MASK ACTIVE: Enable/disable the motion detection mask display.
WIDTH: Change the width of motion detection mask using the LEFT or RIGHT button.
HEIGHT: Change the height of motion detection mask using the UP or DOWN button.
MOVE HOR: Move the motion detection mask area horizontally using the LEFT or
RIGHT button.
MOVE VER: Move the motion detection mask area vertically using the UP or DOWN
button.
SHADING: This feature will correct the inconsistent brightness level in the image.
GAMMA: This feature will adjust video output brightness.
Select the GAMMA level from STANDARD, STRAIGHT, LOW, MIDDLE, and HIGH using the LEFT
or RIGHT button.