Marshall Electronics CV360-CGB - Manual (Page 11)

- 11 -
3. Genlock Description
Menu / System /
Genlock
Disable Genlock Signal : No Input / No Output
Master Genlock Output Mode : Menu setup to “Back
Panel : Sync Out”
Slave Genlock Output Mode : Menu setup to “Back
Panel : Sync In”
Genlock
Resolution
Supported
50hz 1920 x 1080 x 25p 1920 x 1080 x 50p
59.94hz 1920 x 1080 x 29.97p 1920 x 1080 x 59.94p
60hz 1920 x 1080 x 30p 1920 x 1080 x 60p
Genlock LED
Slave
ON Genlock Sync Lock : Operation OK
OFF Genlock Sync Lock : Operation has a problem
BLINK Genlock Sync not Supported (Not Supported Resoltuion or other signal)
TEST
Oper. 1) Setup No. 1 Camera to Genlock Master in Menu. (Back
Panel : Sync Out) Resolution setup
Oper. 2) Setup No. 2 Camera to Genlock Slave in Menu. (Back
Panel : Sync In)
Oper. 3) No. 1 Camera a LED ON / No. 2 Camera LED OFF
Oper. 4) Connection of Sync Line with No. 1 and NO.2 Cameras
Oper. 5) No. 2 Camera a LED ON in 5 seconds
Caution
on Setup
Ref. 1) Resolution mode is off when Genlock mode is slave
Ref. 2) 720p/ 50i/ 60i setup is not available on Genlock non-
supporting Resolution
Ref. 3) On connection of one master and multiple slaves,
repeater is required for sync signal
Ref. 4) Genlock Sync out Outputs Tri-Level 1.2Vp.p