Marshall Electronics CV360-CGB - Manual (Page 10)

- 10 -
DIS ◀
OFF /ON ◀
SYSTEM ◀ OFF /ON ◀
VERSION
COM ◀
I MAGE RANGE
COLOR SPACE
GENLOCK
FREQ
FRAME RATE
SHADI NG-EDT ◀
EDFECT-DET ◀
COLOR BAR
CVBS
CAM TI TLE
LVDS DELAY
RESET ◀
RETURN ◀
EXIT
MOTION ◀
OFF /ON ◀
RANGE
FILTER
AUTO C
RETURN◀
6. WHITE BAL AUTO : < AUTO /AUTOext /PRESET/MANUAL >
1) AUTO : auto accumulation mode
Automatically adjust the color in environmental change of
2,300 K ~ 2,800 K
2) AUTOext : Outdoor and special lighting tracking mode,
White detection for special lighting such as mercury Operating
range of 2,300 K ~ 2,800 K
3) PRESET : It is for finding the best WB in current surveillance area
Hold “ SET button” to activate, or fixed
4) MANUAL : Adjust color in manual
① C-TEMP : normal color temperature value
< 3000K, 5000K ,8000K>
② R-GAIN < 0 ~ 20 steps, 10 >
③ B-GAIN < 0 ~ 20 steps, 10 >
8. IMAGE
1) SHARPNESS : Set the basic brightness of display
< 0 ~ 15 steps,
7 >
2) COLOR GAIN : Set the color value of display
< 0 ~ 20 steps,
15 >
3) GAMMA : Set the gamma value of display
< 0.45, 0.55, 0.65,0.75 /
0.55 >
4) MIRROR : Change the left and right position
< OFF /ON >
5) FLIP : Change the up and down position
< OFF /ON >
6) D – ZOOM : Set the magnification of display
< 1.0X~16.0X,
1.0X >
7) ACE : Auto adjust brightness mode
< OFF /LOW/MIDDLE/HIGH >
8) DEFOG : Compensate the fog
< OFF /ON > ◀
① MODE( AUTO /MANUAL)
② LEVEL(LOW/ MIDDLE /HIGH)
9) SHADING : Correct the differences between the display
brightness in lens curve
<
OFF /ON > ◀
① WEIGHT(0~100%), 100%
SETUP
MENU
5. DAY & NIGHT
1) MODE : Set the Day and Night on display
<
AUTO /B/W /COLOR /EXTERN > ◀
① AUTO : Artificially judge Day&Night through the inner AGC
value of SET
② B/W : keep the display in black regardless of Day&Night
③ COLOR : keep the display in color regardless of Day&Night
④ EXTERN : Artificially judge Day&Night by external censor
(but, DELEY value is applied same in AUTO and EXTERN mode)
2) IR-LED : LED ON/OFF Signal output
< OFF /ON >
3) ANIT-SAT : Adjust the IR brightness in B/W state
< 0 ~ 20 steps,
10 >
4) AGC THRES : Set the level range of the Day&Night judgement
detection.
< 0 ~ 20 steps,
10 >
7. DNR : < OFF/LOW/ MIDDLE /HIGH >
Set the display noise remove condition (AGC) at low luminance
5) AGC MARGIN: Set the level range of the Day&Night judgement
detection(margin)
< 0 ~ 20 steps,
10 >
6) DELEY : delay the time from day to night
<
LOW , MIDDLE, HIGH >