MCZ Vivo 70 Wood - Manual (Page 31)

Chapter 5
INSTALLATION AND USE MANUAL
page
31
Comfort air kit Technical service – MCZ Group S.p.A. all rights reserved - Reproduction prohibited
5.6. INSTALLATION OF TEMPERATURE PROBE
The temperature probe must be connected to the control unit and to
the duct (1) of a kit (see diagram below) and has a length of 2.5 m.
Greater distances require the use of and extension to be provided by
the installer.
PROBE INSTALLATION
 Insert the plastic piece C in D and screw in B without forcing it.
On the threaded part of piece D insert washer E
 The group thus formed A1 must be inserted on the rigid part of
the cable of probe A
 Identify the pass-through hole for insertion of the probe on the
duct (1); on the grille at lower right alongside the fan.
 Insert in the hole the cable of probe A with the block A1 and
secure it on the other side with the nut F
 Insert the other end of the cable of probe A in the control unit
in the indicated position (12-11)
A1
F
B
A1
A
B
C
D E
F