MCZ Flux HYDRO - Manual (Page 21)

19
3 - DRAWINGS AND TECHNICAL CHARACTERISTICS
Technical Dept. - All rights reserved - Reproduction is prohibited
TECHNICAL CHARACTERISTICS FLUX HYDRO
Nominal output power
16 kW (13760 kcal/h)
Nominal output power (H
2
O)
13,5 kW (11610 kcal/h)
Minimum output power
4,5 kW (3870 kcal/h)
Minimum output power (H
2
O)
3,4 kW (2924 kcal/h)
Efficiency at Max
95,6%
Efficiency at Min
97,1%
Temperature of exhaust smoke at Max
90°C
Temperature of exhaust smoke at Min
50°C
Particles/OGC/Nox (13%O
2
)
14 mg/Nm 3 - 2 mg/Nm 3 - 107 mg/Nm 3
CO at 13% O
2
at Min and at Max
0,046 - 0,014%
CO
2
at Min and at Max
7,0 - 11,1%
Maximum water pressure 2,5 bar - 250 kPa
Recommended draught at Max power***
0,10 mbar - 10 Pa***
Recommended draught at Min power
0,02 mbar - 2 Pa
Smoke mass 9,8 g/sec
Hopper capacity 33 litres
Type of pellet fuel Pellet diameter 6-8 mm and size 3-40 mm
Pellet hourly consumption Min ~ 1 kg/h* - Max ~ 3,3 kg/h*
Autonomy At min ~ 21 h* - At max ~ 7 h*
Heatable volume m 3 344/40 – 393/35 – 459/30 **
Combustion air inlet 0 50 mm
Smoke outlet 0 80 mm
Air intlet 80 cm 2
Rated electrical power (EN 60335-1) 80 W (Max 420 W)
Supply voltage and frequency 230 Volt / 50 Hz
Net weight 180 kg
Weight with packaging 190 kg
Distance from flammable material (back) 10 mm
Distance from flammable material (side) 20 mm
* Data that may vary depending on the type of pellets used
** Volume that can be heated, according to the power requirement per m 3 (respectively 40-35-30 Kcal/h per m 3 )
***Value recommended by the manufacturer (non-binding) for optimal product operation
Tested according to EN 14785 in accordance with European regulation for Construction Products (UE 305/2011)