Silvercrest SMS 5.0 A1 - Manual (Page 15)

SilverCrest SMS 5.0 A1
English - 13
Inserting slides
 Open the slide holder at the point marked "OPEN". Place up to four framed slides in the device
as shown in the following image. Make sure that the slides are not inserted the wrong way
around or upside down.
 Close the slide holder.
 Insert the backlight rail, with the reflective surface facing upwards, in the backlight slot [10] until it
noticeably snaps into place.
 Insert the slide holder, with the inscription facing upwards, in the direction of the arrow in the
negative/slide slot [7]. Insert the slide holder in until it noticeably snaps into place in the first
position. For more slides, insert the slide holder in further until it noticeably snaps into place in the
next position.
 To record the slides, please read the section "Recording" from page 17.
 Remove the backlight rail and the slide holder after you have recorded your slides. You remove
the backlight rail by pressing it down lightly on the protruding point and pulling it out.