Silvercrest SZA 28 B2 - Manual (Page 12)

9 SZA 28 B2
GB
Electrical connection
The power for the indoor aerial can be delivered via supplied the mains
adapter 5 or via a receiver with a 5 V remote power supply.
CAUTION
► Before connecting the device, compare the specifi cations for the required
input voltage on the rating plate with the intended voltage source for
operation. This data must agree in order to avoid damaging the product.
► The power socket must be easily accessible so that the mains adapter 5
can be easily disconnected in an emergency.
► Check to ensure that the mains adapter cable 5 is not damaged and
that it is not routed over hot surfaces and or sharp edges, otherwise it
could be damaged.
► Ensure that the mains adapter cable 5 is not stretched tight or kinked.
Power adapter
♦ Connect the low voltage plug of the mains adapter 5 to the power socket 4
on the rear of the device.
♦ Plug the mains adapter 5 into a properly installed power socket.
Receiver with 5 V remote power supply
♦ Ensure that your receiver has a 5 V remote power supply via the aerial
output and that this is switched on. Consult the operating manual of your
receiver for further information.
♦ Connect the aerial cable 2 from the indoor aerial to the aerial con-
nection on your receiver. The indoor aerial will now receive its power
via the aerial output of the receiver.
IB_93403_SZA28B2_LB4.indb 9 IB_93403_SZA28B2_LB4.indb 9 05.12.13 11:35 05.12.13 11:35