Silvercrest SZA 28 B2 - Manual (Page 10)

7 SZA 28 B2
GB
Handling and use
In this chapter you will receive important information on the handling and
operation of the device.
Selection of set-up location
The indoor aerial can be set up in two positions (horizontally or vertically)
(see Fig. A + B).
♦ Attach the stand 6 to the corresponding recess on the rear of the device.
♦ Place the device on a smooth, level and slip-resistant surface.
♦ To ensure good reception, select a set-up location as near as possible to
the window. Do not place the device on the fl oor, but rather on a raised
surface.
♦ Do not place the device in the vicinity of high-frequency devices such
as microwaves. If they are operated simultaneously, this can lead to
interference.
Fig. A Fig. B
Wall mounting
The supplied wall mount 7 can be used for mounting the indoor aerial
in a horizontal/vertical position on a wall.
Required tools
To mount the aerial you will need a drill with a 6 mm masonry bit, a Philips
screwdriver, a spirit level, a folding ruler and a pencil. The supplied wall
plugs are only suitable for a mounting on concrete or stone. Check the suit-
ability of your wall before mounting. If in doubt, consult a professional.
6
6
IB_93403_SZA28B2_LB4.indb 7 IB_93403_SZA28B2_LB4.indb 7 05.12.13 11:35 05.12.13 11:35