Silvercrest SHLF 2000 B1 - Manual (Page 51)

SHLF 2000 A1 49
7. Cleaning
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
from the protective guards with a
vacuum cleaner.
2. Remove any remaining dirt with a soft
brush.
Take care not to let any dust fall inside
the appliance. You should therefore hold
the appliance so that the protective
guard you are in the process of cleaning
is facing downwards.
3. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
4. Wipe the appliance with a cloth
moistened with clear water.
5. Do not use the appliance again until it
has dried completely.
8. Troubleshooting
Fault Cause Remedy
Appliance cannot be
switched on Faulty fuse or wall socket Select another wall socket
Faulty appliance Have repairs carried out at a specialist
workshop or dispose of the appliance. You
will find the service address in “Service
Centre” on page 52.
Appliance cannot be
switched off Faulty electronic components Have repairs carried out at a specialist
workshop or dispose of the appliance. You
will find the service address in “Service
Centre” on page 52.
Appliance switches off
automatically Safety switch has triggered Set the appliance upright (see “6.9 Safety
switch” on page 48)
Thermal cut-out has triggered Allow the appliance to cool down (see
“6.8 Thermal cut-out” on page 48)
Clean the appliance (see “7. Cleaning” on
page 49)
RP100043 Heizlüfter mit LCD und FB LB5 Seite 49 Donnerstag, 25. September 2014 2:12 14