6 setting the operating time, 7 swivel function, 8 thermal cut-out – Silvercrest SHLF 2000 B1 User Manual
Page 50: 9 safety switch

48
The selected required temperature is shown
in the display 10.
The room temperature is measured by the
temperature sensor 7.
The appliance switches off as soon as the
room reaches the required temperature. If
the room temperature falls below the
required temperature, the appliance
switches on again automatically.
6.6 Setting the operating time
The appliance has a timer with
which you can set the required
operating time. The appliance
switches off automatically once the
operating time has expired.
1. Press the “H” button 16 or 25 to set the
hours.
2. Press the “M” button 15 or 24 to set the
minutes.
Note: If you press and hold the buttons, the
values will continue to run until you release
the button again.
The selected operating time is shown in the
display 10.
6.7 Swivel function
The appliance has a swivel function.
This causes the appliance to swivel to and
fro, distributing the exiting air more evenly
through the room:
1. To switch the swivel function on, press
the swivel function button 17 or 21.
2. To switch the swivel function off, press
the swivel function button 17 or 21
again.
6.8 Thermal cut-out
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch 8 to 0 to switch
off the appliance.
2. Check whether the air inlet or outlet is
obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.
6.9 Safety switch
The appliance is protected against
accidental damage by a safety switch.
The safety switch is
located on the bottom
of the appliance and
switches the appliance
off immediately should
it fall over:
1. Return the appliance to an upright
position.
2. Select the required function again (see
“6.1 Displays” on page 47).
RP100043 Heizlüfter mit LCD und FB LB5 Seite 48 Donnerstag, 25. September 2014 2:12 14