beautypg.com

Unpacking, setting up and inserting the battery, 1 setting up the appliance, 2 inserting the battery – Silvercrest SHLF 2000 B1 User Manual

Page 48

background image

46

5. Unpacking, setting up and inserting the battery

5.1 Setting up the appliance

Note! As the appliance and heating coils
are supplied with a thin film of grease, there
might be a small amount of smoke and
odour the first time the appliance is used.
This is not harmful and will stop after a short
while. Ensure meanwhile that there is
sufficient ventilation.
1. Unpack the appliance from the

packaging.

2. Remove the transport packaging.

Note: There is a piece of corrugated
cardboard positioned between the
appliance and the base 9. This must
also be removed.

3. Check that the appliance shows no signs

of damage.

Warning! Ensure that there is
sufficient distance from the wall,
fixtures and other appliances. The
distance must be at least 0.5 m to
exclude the risk of fire.

4. Select a location that complies with the

safety information (see “4. Safety
information” on page 42).

5. Select a location where the flow of hot

air is not directly aimed at people,
animals or plants.

6. Plug the mains plug into a wall socket

that complies with the technical data.
Note: The appliance consumes up to
10 amperes of current (2,000 watts). If
you have plugged other power
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.

5.2 Inserting the battery

If the appliance is new or the battery in the
remote control is flat, a new type CR2032
battery must be inserted.
1. Press the catch

towards the
middle and pull
out the battery
compartment.

2. Remove the old

battery if present.
Note: Please observe the instructions
for disposal (see “9.2 Disposable/
rechargeable batteries” on page 50).

3. Insert a new battery.

Note: Ensure the correct polarity (+/–)
when inserting the battery. The correct
polarity is marked on the battery
compartment. The negative pole of the
battery must point upwards.

4. Slide the battery compartment back in

again.

RP100043 Heizlüfter mit LCD und FB LB5 Seite 46 Donnerstag, 25. September 2014 2:12 14