Elmo Ceiling Presenter HV-C1000XG - Manual (Page 38)

37
1
2
3
4
5
6
7
8
9
10
11
• The lamp is very hot immediately after use. Direct contact
with the lamp or lamp cover will cause burns. Make sure that
lamp is thoroughly cooled off (30 minutes or more) before
replacing the lamp.
• Replacement of the lamp requires a work done at a high
location. Take care not to cause accident.
CAUTION
• Use JR12V50W AKM/5EZ-1 manufactured by Phillips for
replacement. Other lamps may blow out or cause fire if used.
WARNING
1. Turn OFF the Power Supply Switch.
2. Remove the power cord.
3. Wait until the lamp is thoroughly cooled off.
4. Remove the lamp cover.
Loosen the fixing screws and displace the lamp
cover in the arrow direction. (Fig. 1)
Turn the lamp cover around the fixing screw.
(Fig. 2)
5. Replace the lamp.
Rotate the lamp and install a new lamp.
6. Install the lamp cover.
Lamp cover shall be installed in sequence
reverseto its removal.
REQUEST
Since the lamp is made of glass, do not touch the glass surface with bare hands, apply a
strong impact, or scratch the surface.
screw
Replacing the Lamp
The lamp that is installed in the product has a certain life span. When the lamp is used for a
long period, the lamp light may become dark or the lamp may go off due to the end of its life.
(The life of the lamp varies according to the utilization condition.) In this case, replace the lamp.
How to replace the lamp
9
REPLACING THE LAMP
( Fig. 1)
( Fig. 2)