Elmo Ceiling Presenter HV-C1000XG - Manual (Page 17)

11
16
1
2
3
4
5
6
7
8
9
10
Simple Steps for Presenting Printed Material
(1) Push the [POWER] button of the wireless
remote control to turn ON the power (Indicator
LED on the unit turns from red to green).
Connection with the monitor should be done in
advance.
If the Power Supply Switch is turned ON
immediately after it is turned OFF, this product may
not operate.
To restart operation, turn ON the Power Supply
Switch after several seconds.
When the document surface is dark, turn ON the
lamp by pressing the [LAMP] button.
After the power supply is turned ON, it takes
about 10 seconds to execute the initialization of
the unit and output the image.
(2) Place an object on the document surface and
adjust the image size using [ZOOM·TELE] and
[ZOOM·WIDE] buttons on the wireless remote
control as you watch the monitor screen so that
the projected image may be in compliance with
the object.
(3) Adjust the focus by pressing the [FOCUS·N/F]
(NEAR/FAR) buttons of the wireless remote
control. The focus can be also adjusted by
pressing the [AF] (AUTO FOCUS) button.
(4) After finishing the operation, turn OFF the
[POWER] button of the wireless remote control.
(Indicator LED on the unit turns from green to
red.)
NORMAL OPEN CLOSE
TELE ZOOM WIDE NEAR FOCUS FAR
AF
CONTRAST LAMP
IMAGE ROTATION F.A.M.
POSI/NEGA COLOR/B&W
IRIS
NORMAL OPEN CLOSE
TELE ZOOM
MENU
WIDE NEAR FOCUS FAR
IMAGE CALL
POWER
PAUSE
AF
SET PRESET CALL SET
Wireless remote control
IRIS
NORMAL OPEN CLOSE
TELE ZOOM WIDE NEAR FOCUS FAR
AF
Wireless remote control
Wireless remote control
5
OPERATION PROCEDURES
(1)
(4)
(2)
(3)