Enviro Sienna Indoor Gas Fireplace - Manual (Page 20)

Secondary Installation
Figure 29: Filler panel with trim installation.
I
NSTALLATION OF
S
URROUND
P
ANEL
:
The Sienna must have one of the panels installed around the unit; the unit panel, the filler panel, or the
filler panel with trim. If you have trim for your filler panel, the trim must be installed before installing the
filler panel onto the unit.
Figure 28: Screw to
hold the trim against
the surround.
Figure 26: Corner brackets
for trim.
1. Attach one side trim to the top trim using a corner bracket (see Figure
26) to secure pieces together. There are two (2) main pieces to each
corner bracket (see Figure 27). When installing the corner pieces into
the trim the “B FACE” sides must face each other and the screw heads
are to face out. With the bracket in place and the top and a side trim
snug together use a flat head screwdriver to turn the two (2) screws in
the bracket in to tighten it into the trim.
2. Slide the two (2) attached trim pieces onto the surround panel.
3. Attach the other side trim piece to the top trim using the same method
used in Step 1.
4. Place the second side of the trim
on the surround panel in the same
manner use on the first side and
secure in the same manner.
5. On the side trims there are holes 2” (50
mm) from either end. Using a Phillips
screwdriver to place a #8 screw 11⁄4”
long in each hole and tighten (refer
to Figure 28). This will keep the trim
tight against the surround.
NOTE: The notch at the bottom of the
left trim is so the power cord can be
run to the outside of the panel.
INSTALLATION: Lift the surround upright in
front of the fireplace with the four (4) hooks
pointing towards the fireplace. Slide the hooks
into their corresponding slots (see Figure 29).
Ensure the hooks are pushed all the way into
the slots and the notch on the hook must be on
the bottom of the slot. The surround should be
wiped with a damp cloth periodically.
REMOVAL: Lift the surround straight up in
order to unhook the notch on the hooks from
the bottom of the slots. Pull the surround out
away from the fireplace. Place the surround
where it will not be damaged.
20
Figure 27: Two pieces of corner bracket.