Silvercrest SWED 500 A1 - Manual (Page 150)

SilverCrest SWED 500 A1
148 - English
Manual tuning control
Instead of using the station search, you also have the option of configuring
stations manually. This makes it possible to find weaker stations as well. To do
this, proceed as follows:
To increase or decrease the frequency by one step, briefly press either the 'UP'
(13) or 'DOWN' (15) button respectively. The spacing of the steps varies
depending on the frequency band selected. For FM it is 0.1 MHz, 9 kHz for
'AM-EU', 10 kHz for 'AM-US', 5 kHz for 'SW' and 9 kHz for 'LW'.
Fine tuning a station
You have the option of refining the tuning resolution of the tuning controls
according to the following table, in the event that a station cannot be exactly
located.
To configure this, do the following:
 When the radio is switched on, press 'MODE' three times.
 The current frequency is displayed on the screen (5) and the current tuning
resolution is shown in the bottom right-hand corner.
 You can now use the 'UP' (13) or 'DOWN' (15) buttons to select set tuning
to normal or fine. The setting will be saved automatically.
Frequency range: Fine / normal tuning
resolution
UKW (FM) 100 kHz / 50 kHz
MW (AM) EU 9 kHz / 1 kHz
MW (AM) US 10 kHz / 1 kHz
SW 5 kHz / 1 kHz
LW 9 kHz / 1 kHz