Silvercrest DAMPRENSER User Manual

Page 49

nozzle (2) in the wand nozzle (1).

N.B.: The nozzle can also be used with the extension tubes, with the special attachment.

Nozzle attachment (4)

The nozzle attachment (4) is fixed to the extension tube so as to connect other attachments to

the tube and make it easier to clean points that are hard to reach (e.g. due to height).

Multipurpose brush (5)

The multipurpose brush can be connected directly to the gun (C) or to the extension tubes,

using the nozzle attachment (4). Using the cover provided (14), which needs to be attached

to the multipurpose brush (5), the brush can be used to remove dust from sofas, armchairs,

throws, mattresses and cushions or pillows. In any case, it is advisable to make sure that the

condensation from the steam flows into the container before and during use, to prevent the

fabric from becoming wet.

Window wiper (6)

It is possible to fit the window wiper (6) to the multipurpose brush (5): position the brush

diagonally on the window wiper so that the rear slots hook onto the tabs and then press the

brush forwards until the window wiper locks into place. The window wiper is used to polish

windows, mirrors and polished surfaces. It is also simple to use in shower cubicles to remove

the build up of scale deposits.

Floor brush (8) with special joint to floor brush attachment (7)

Fit the floor brush (8) to the extension tubes (9) using the relevant attachment (7) . It is advis-

able first to fit the floor brush to the attachment, then the floor cloth to the brush and finally,

to fit the attachment to the extension tube. The floor brush has handy hooks to which it is

possible to fit any type of machine-washable floor cloth, as well as the cloth provided (13).

To secure the cloth, place the brush on it and then tuck the cloth sides into the brush.

Extension tubes (9)

The extension tubes are inserted into one another. To separate them, use the release button.

The extension tubes are used with the floor brush and the proper attachment (7); they also

make it easier to use when cleaning points that are difficult to reach, when fitted with the

nozzle attachment (4) and the proper attachment.

Attachment bag (10)

The appliance is provided with a practical bag for attachments, keeping them within easy

reach at all times.

fILLING THE BOILER TANK DURING USE

If water should leak out of the boiler tank during use, switch off the appliance from the On/

Off switch (G), unplug it from the mains and proceed as follows:

Press the steam button (A) to discharge any remaining steam;

•

Slowly loosen the safety cap (I) and wait a few seconds until the whistling of the steam

•

can no longer be heard. Empty the boiler tank completely and wait a few minutes before

refilling the boiler tank;