Silvercrest DAMPRENSER - Manual (Page 48)

46
GB
GB
Operation
The steam ready light (F) will switch on and off during operation to show that the appliance •
has reached working pressure.
To prevent the steam from being dispensed accidentally, the lock cursor (B) must be moved •
from the left to the right ( ); to release the steam function, move the cursor (B) from right
to left ( ) (Fig. 3).
To dispense steam, press the button (A) on the gun (C). •
When using for the first time, it is a good idea to spray the steam jet into a container to get •
rid of any water residues that might be inside the tube (any water coming out is because
of the condensed steam inside the tube). This action needs to be repeated even after a
few minutes of appliance inactivity. In any case, when the gun begins to dispense steam,
always point the jet downwards to the ground.
IMPORTANT: When the appliance is not used, always block the steam
button (A) using the relevant cursor (B).
During the first use, it is possible for odours to form; this is nothing to worry about.
Make sure that the room is suitably ventilated.
Switching off the appliance
After use, switch off the appliance, using the switch (G) and unplug it from the mains power •
socket. Clean the attachments and boiler tank as described in the “CLEANING AND
MAINTENANCE” section.
Wind the hose around the body of the appliance (H) and fit the gun (C) over the handle •
(J), after placing the cursor (B) in the lock position.
ATTACHMENTS
Wand nozzle (1)
This attachment serves for deep-down cleaning of all surfaces affected by stubborn dirt. The
nozzle can be fitted directly to the gun (C) or to the extension tubes (9) using the attachment
(4). Position the nozzle slot upwards in the centre, then turn it clockwise into gun until it locks
into place.
Round brush (2)
The round brush (2) is used to remove stubborn stains, such as those found on cook tops or
in the cracks between tiles. It can also be used to clean bathroom fixtures, sinks, showers or
bath tubs, removing all traces of scale buildup.
It is used with the wand nozzle (1): first fit the nozzle (1) onto the nozzle of the gun (D) – as
described above – then insert the round brush (2) into the nozzle.
N.B.: The nozzle can also be used together with the extension, with the special attachment.
Angled nozzle (3)
This attachment is used together with the wand nozzle (1).
The angled nozzle is especially useful for points that are difficult to access in order to remove
dirt quickly and easily from hidden corners such as radiators, blinds and bathroom fixtures.
Fit the angled nozzle (4) to the gun nozzle (D) –as described above – then insert the angled