Setting the station – Silvercrest SWEP 500 A1 User Manual

Page 124

Sleep function

You can activate the sleep function via the

SNOOZE

button. You can set a

time of up to 90 minutes in ten-minute steps, after which the radio will auto-
matically turn itself off. To do so, first switch the radio off.
•

Press the

SNOOZE

button. The symbol for the sleep function

and

90 (for 90 minutes) will appear.

•

Press the

SNOOZE

button repeatedly until 90 is displayed to count down

the sleep time in 10 minute steps.

•

Either select a sleep time (the sleep symbol

remains on the screen)

or press

SNOOZE

again until 00 appears on the screen.

The sleep time is now switched off.

Setting the station

•

Select the required frequency band (FM, MW, LW or SW), using the
frequency select button.

The corresponding abbreviation will appear on the screen.
•

The

and

DOWN

buttons can now be used to set the desired frequency.

•

If you keep

DOWN

pressed for about three seconds, the automatic

station search will start.

•

The search stops as soon as a station with sufficient signal strength is
found.

Setting the MW band

Since the radio transmitter systems differ from one country to another,
you should make the appropriate setting via the reception range setting:
•

With the radio switched off, press the button

MODE

six times and then

select, using the buttons

resp.

DOWN

, the appropriate reception range

as per the following table:

- 121 -

IB_79840_SWEP500A1_LB2 04.01.2013 10:48 Uhr Seite 121