Silvercrest SWEP 500 A1 - Manual (Page 111)

General functions
Key lock
In order to prevent changing the settings unintentionally by touching the
buttons, you can activate the key lock.
•
With the radio switched on, press and hold the button MEM for about
3 seconds. On screen, the message flashes. All buttons, except
the buttons SNOOZE and MEM , are now blocked.
• Press and hold down the MEM button again for about 3 seconds to
cancel the key lock. The message on the screen disappears.
Screen lighting
• Press any button to illuminate the screen. The screen will remain lit for
about 15 seconds.
Stand
• Fold out the base on the rear of the device to make the device
more stable.
Time functions
When the power provision is established (mains or battery operation) the
time indicated by the world receiver begins at “0:00 00” Proceed with set-
tings the date and time, as explained in the following sections.
The time functions can only be programmed when the radio is switched off.
If the device is disconnected from mains power or the batteries are remo-
ved, the settings are lost.
- 108 -
GB
IB_79840_SWEP500A1_LB2 04.01.2013 10:48 Uhr Seite 108