Silvercrest SWEP 500 A1 - Manual (Page 122)

Countdown function
The countdown function is only available when the radio is switched off.
Set and save countdown
• Press and hold down the MEMORY SCAN button for around 2 seconds,
the screen shows 0.00 D. The D blinks.
• Press the UP or DOWN button to set the desired time.
5 countdown times are preset on the memory buttons and you can open
these directly using the corresponding memory button:
Button
M.0/5 5:00 Button M.1/6 10:00
Button M.2/7 15:00 Button M.3/8 20:00
Button M.4/9 25:00
• Press the MEM button to save the set time, the memory space indicator
MEM flashes on the screen. Now use the M.0/5 – M.4/9 buttons to select
a memory space; when you press the relevant memory key the time is
saved in this memory space and the time previously stored there
overwritten.
• When the MEMORY SCAN button is pressed again you leave the
countdown mode.
Call up and activate the countdown function
• Press and hold down the MEMORY SCAN button for around 2 seconds,
the screen shows 0. 00 D.
• Select the desired, saved countdown time with the aid of the M.0/5 – M.4/9
memory buttons.
• Press SNOOZE to start the countdown. Pressing the SNOOZE button again
pauses the countdown.
When the set time has been counted down, an alarm sound plays for one
minute becoming gradually higher in tone and louder.
•
Press the MEMORY SCAN button to pause the countdown and leave
countdown mode.
- 119 -
GB
IB_79840_SWEP500A1_LB2 04.01.2013 10:48 Uhr Seite 119