Elektra Beckum Mega 500 D - Manual (Page 8)

15
ENGLISH
diameter 8 mm.
Stock-no. 090 105 4550
Accessory kits
L
Accessory Kit LPZ 7-S
comprising: Blow gun, tyre inflator
gauge, tyre valve nozzle, needle tip
nozzle, paint spray gun, spray gun,
self-storing coil air hose.
Stock-no. 090 100 3858
• Accessory Kit LPZ 7-P
(not illustrated)
comprising: Blow gun, tyre inflator
gauge, tyre valve nozzle, needle tip
nozzle, paint spray gun, spray gun,
10 m braided air hose.
Stock-no. 090 100 3890
• Accessory Kit LPZ 6 (not illustrated)
comprising: Blow gun, tyre inflator
gauge, tyre valve nozzle, needle tip
nozzle, paint spray gun, 5 m braided
air hose.
Stock-no. 090 104 4487
• Accessory Kit LPZ 4 (not illustrated)
comprising: Blow gun, tyre inflator
gauge, paint spray gun, self-storing
coil air hose.
Stock-no. 090 101 3845
• Accessory Kit LPZ 2 (not illustrated)
contains change handle with blow
gun, tyre inflator gauge, paint spray
gun, self-storing coil air hose.
Stock-no. 090 105 5971
A
Danger!
Prior to all servicing:
− Switch Off.
− Unplug.
− Wait until the compressor has
come to a complete stop.
− Ensure the compressor and all air
tools and accessories connected
to it are relieved from pressure.
After all servicing:
− Check to see that all safety
devices are operational.
− Make sure that no tools or other
parts remain on or in the
machine.
Compressor does not run:
• No mains voltage.
− Check cables, plug, outlet and
mains fuse.
• Mains voltage too low.
− Use only extension cables with
sufficient lead cross section (see
"Technical Specifications"). Avoid
using extension cable with cold
machine.
• Compressor was stopped by
unplugging.
− Switch compressor OFF at the
On/Off switch, then ON again.
• Motor has overheated, caused by
insufficient cooling (cooling fins cov-
ered).
− Remove cause for overheating
and allow to cool down for
approx. 10 minutes, then start
again.
Compressor runs but does not build
up sufficient pressure.
• Drain cock on cup of filter/regulator
unit open.
− Close drain cock.
• Check valve leaky.
− Have check valve serviced by
qualified service centre.
Air tool is not supplied with sufficient
pressure.
• Pressure regulator not opened wide
enough.
− Open pressure regulator more.
• Hose connection between compres-
sor and air tool leaky.
− Check air hoses, replace defec-
tive parts if necessary.
A
Danger!
Repairs to electric tools must
be carried out by qualified electrici-
ans only!
Electric tools in need of repair can be
send to the service centre in your coun-
try. See spare parts list for address.
Please attach a description of the fault to
the electric tool.
The machine's packaging can be 100 %
recycled.
Worn out machines and accessories
contain considerable amounts of valua-
ble raw and plastic materials, which can
be recycled.
These instructions are printed on chlo-
rine-free bleached paper.
7. Trouble Shooting
8. Repairs
9. Environmetal protection