Elektra Beckum Mega 500 D - Manual (Page 6)

13
ENGLISH
5.1 Periodic maintenance
Prior to each use
• Check air hoses for damage,
replace if necessary.
• Check all screwed connections for
tightness, tighten if necessary.
• Check power supply cable for dam-
age, if necessary have replaced by
a qualified electrician.
Every 50 operating hours
• Check air filter element (26) of com-
pressor pump, clean if necessary.
• Check oil level (27) of compressor
pump, top up if necessary (28).
• Drain condensate from pressure
vessel (30).
• Clean air filter element (31) of filter/
regulator unit.
.
• Drain condensate from filter/regula-
tor unit (32).
• Check V-belt:
− Remove belt guard (33).
− Retension V-belt or replace, if
necessary.
− To adjust the V-belt tension,
loosen the four screws at the
motor base and shift the motor.
− Tighten the screws at the motor
base again.
− Replace the belt guard.
Every 250 operating hours
• Replace air intake filter element of
compressor pump.
• Replace air filter element of filter/
regulator unit.
Every 500 operating hours
• Drain oil from compressor pump
through the drain plug (29) and fill
with fresh oil.
A
Dispose of the waste oil envi-
ronmentally safe by taking it to a
proper collecting point!
Every 1000 operating hours
• Have unit serviced by an authorized
service station. This will extent the
compressor's service life considera-
bly.
5.2 Machine storage
1. Switch unit OFF and unplug.
2. Release pressure from tank and all
connected air tools.
3. Store machine in such way that it
cannot be started by unauthorized
persons.
A
Caution!
Do not store machine unpro-
tected outdoors or in damp environ-
ment.
Do not lay machine on its side for
transportation or storing.
For special applications the following
accessories are available at your spe-
cialist dealer – see back cover for illus-
trations:
Sealing
A
Air Caulking Gun KP 910
for commercially available car-
tridges.
Stock-no. 090 101 0030
Sheet metal cutting
B
Air Nibbler BN 540
extra small cutting radius; cuts steel
sheet up to 1.0 mm thickness.
Stock-no. 090 100 6784
Drilling
C
Air Drill BM 310
especially handy tool for low-fatigue
working; right-hand rotation only.
Stock-no. 090 100 6725
• Air Drill BM 500 (not shown)
with 3/8" keyless chuck, fully revers-
ible with quick reverse feature.
Stock-no. 090 105 4533
Stapling / nailing
D
Combination Air Stapler/Nailer
Kombi 40/50
for staples (type 90) from 20 mm to
40 mm and finishing nails (type
SKN) from 20 mm to 50 mm.
Stock-no. 090 105 4720
• Combination Air Stapler/Nailer
Kombi 32 (not illustrated)
for staples (type 90) from 15 mm to
32 mm and finishing nails (type
SKN) from 16 mm to 32 mm.
Stock-no. 090 105 4711
26
27
29
28
30
31
32
O OFF
AUTO
33
6. Available Accessories