Silvercrest WD1610 - Manual (Page 89)

Wireless Door Bell WD1610
88 - English
- Drill two 6mm holes at a distance of 50mm
in the wall.
- Insert two of the supplied rawlplugs into
these holes.
- Insert two of the supplied screws through
the holes located in the bottom piece of the
transmitter housing and then screw them
onto the rawlplugs.
- Replace the upper housing piece by
pushing it onto the base unit piece.
Mounting the Receiver
- Drill one 6mm hole at the desired position
on the wall.
- Insert one of the supplied rawlplugs into this
hole.
- Screw one of the supplied screws into the
rawlplug until its head is approx. 2mm away
from the wall.
- Place the receiver onto the screw head.
The wall-mounting hole located at the back
of the housing must completely fit over the