Silvercrest WD1610 - Manual (Page 87)

Wireless Door Bell WD1610
86 - English
polarity (+ and -). The correct polarity is
labelled on the batteries and inside the
battery compartment.
- Slide the battery compartment cover onto
the receiver housing.
Battery for the Transmitter
- To open the transmitter housing, use a flat
screwdriver. Insert the screwdriver carefully
into the transmitter housing side and press
it slightly inwards to release the nose latch
(8). Then pull the upper housing piece
upwards.
- Insert the supplied A23-sized 12 V battery
into the upper transmitter housing piece.
The correct polarity is labelled on the
battery and inside the transmitter housing.
- Replace the upper housing piece onto the
transmitter base unit.
You may also leave the base unit piece
separated if you want to mount the
transmitter on the wall.