Silvercrest SSMK 40 B2 - Manual (Page 29)

33 GB/MT
Before use / Bringing into service / operation
Before use
CAUTION! Remove the transporta-
tion lock for the massage mechanism
before you start to use the device.
To do this, remove the screw using the provided
tool on the rear side of the cushion. If this screw
of the transportation lock is not removed and
the Shiatsu cushion is used at one, the cushion
will be damaged irreparably and unusable. In
this case no warranty will be assumed.
Always employ the transportation lock screw
for the duration of any further transport in the
future. Every transport without a transportation
lock can damage the device irreparably.
Bringing into service / operation
Note: Only use the device in an upright position,
never lay it flat on the floor.
Note: The zip fastener on the Shiatsu cushion may
not be opened because it is only there for technical
reasons.
Note: The device may give off an odour of plastic
on first use. This odour will cease to develop after a
short while.
Note: The device automatically switches off after
15 minutes. Use the shiatsu cushion for a maximum
period of 15 minutes. Longer use may lead to
over-stimulation and hence tension in the muscles.
Note: Ensure that you are sitting in the middle of
the device and that the massage heads
3 can
move to the left and right of your spine.
Note: Do not lie, sit and stand with your full
weight on the moving parts of the device and do
not place any objects on the device.
Insert the mains plug into the mains socket.
Position the lead to avoid creating a trip hazard.
Switching on / off:
Switch on the Shiatsu cushion by pressing the
On / Off button 4 .
After use, switch off the Shiatsu cushion by
pressing the On / Off button 4 .
Back massage:
Select with button A+B 6 , A 7 or B 8 the
area you would like to have massaged:
A+B: your whole back
A: upper back
B: lower back.
The LED lamp signalises the massage area that
has been set.
Note: When you select the massage area, the
automatic switch-of will be activated and set at
15 minutes.
Press the ently 9 , employing the appropriate
frequency, to set the automatic switch-off at 5,
10 or 15 minutes.
Note: By resetting the timer setting, the timer
will begin counting anew. At the beginning of
the massage, select the maximum duration of
the massage and do not change this during the
massage in order to prevent the device from
overheating.
Note: Ensure that you are experiencing the
massage as pleasant and relaxing. If necessary,
vary the pressure and / or your position. Stop the
massage at once if it is painful or unpleasant.
Heating function:
Press the heat button 5 , to activate the heating
function.
Press the heat button 5 once again to deacti-
vate the heating function.
Note: The heating function cannot be activated
unless a massage program has ben previously
selected.
Seat vibration:
Press the seat vibration button 10 to activate
the seat vibration. The vibration starts at a low
intensity and the relevant LED for seat vibration
will light up.
Press the seat vibration button 10 , with the
appropriate frequency, to switch to low, medium
or high intensity or to deactivate the seat vibration.
Note: The seat vibration can be activated
together with the back massage. However, the
vibration intensity will be slightly reduced in
this case.
68944_silv_Shiatsu_Sitzauflage_SSMK40_Content_LB5.indd 33 23.08.11 13:10