EMC Qlogic QLA23xx - Manual (Page 57)

3
Configuring a CLARiiON Boot Device 3-25
Configuring an EMC Boot Device
5. Start the BfS deployment by dragging and dropping the BOOT
FROM SAN BL20p script task to the BfS server new computer.
Installation time is approximately 50 minutes.
What Next? Verify that the Fibre Channel HBA drivers and (Windows 2000 only)
digital signatures are installed and started, as described in the next
section.
Verifying HBA Driver
and Digital
Signature
Installation You should install the HBA driver again here to ensure that the
EMC-required settings are implemented. From the desktop, perform
the appropriate steps:
◆ Windows NT: Follow the procedure under Installation Procedure
for Windows NT Hosts on page 2-15.
◆ Windows 2000: Follow the procedure under Updating the HBA
Driver in a Windows 2000 or Windows 2003 Host on page 2-17.
If duplicate devices appear in the Disk Drives section or Disk
Administrator
display, you have made errors in the switch fabric
zoning configuration. Refer to refer to Preparing the Fabric on
page 3-15 for the correct configuration procedure.
If you do not have a driver for Windows 2000 that is digitally signed, check
the EMC section of the QLogic website for an updated driver. (Refer to Where
to Find the Driver on page 2-14.)
What Next?
From here:
◆ If you need to install multipath and failover software, refer to
Installing Multipath and Failover Software.
◆ If you need to start the installation again, refer to Starting a Fresh
Installation.
◆ Otherwise, installation and setup are complete.