Silvercrest SMZS 1600 A1 - Manual (Page 67)

67
3 Operation
GB
MT
5. Set the nozzle switch to "carpet" or "hard floor" accord-
ing to the floor (Fig. 15) to be cleaned:
- Hard floor (Fig. 15/a)
Parquet, laminate, tiles, PVC, etc.
- Carpet (Fig. 15/b)
Short- and deep-pile carpets, rugs, etc.
6. When working with the vacuum cleaner, pull if after you
like a sleigh.
3.2 If anything has acci-
dentally caught in the
vacuum or been vacu-
umed up If objects (such as curtains, etc) have caught in the
vacuum cleaner:
1. Sometimes it is sufficient to open the bypass vent
(Fig. 17), thus reducing the suction power.
2. Otherwise, switch off the cylinder vacuum cleaner with
the on/off switch (Fig. 18/1) and pull the plug from the
mains socket.
If you vacuum up objects by accident
1. Switch off the cylinder vacuum cleaner with the on/off
switch (Fig. 18/1) and pull the plug from the mains sock-
et.
2. Proceed as described in
ZChapter 4.1, "Emptying the
dust container".
NOTE:
In normal situations the bypass vent (Fig. 16) must be
completely closed. With the bypass vent you can quickly
reduce the suction power, to release objects such as cur-
tains that have been sucked in.
NOTE:
Your vacuum cleaner is equipped with a safety switch to
prevent overheating. It automatically cuts off the power
supply if the motor is overheated. In this case switch off
the vacuum cleaner with the on/off switch and pull the
plug from the mains socket. Eliminate the cause of over-
heating (e.g. clogged suction paths). Wait for about
45 minutes. After the appliance has cooled off, you may
switch it on again.
b
a
15
16
17
18
66492_Silvercrest_Multicyclone-Bodenstaubsauger_SMZS_1600_A1__ES_IT_PT_GB_DE.pdf 66 20.05.2011 09:27:57