Silvercrest SSR 1080 B2 - Manual (Page 129)

Satellite Receiver SSR 1080 B2
English - 127
A/V Control
TV Type
Select the TV standard for your country.
PAL Used in most European countries.
SECAM Used in France and Eastern Europe.
This setting applies only to the video output but not the picture in
HDMI mode.
TV Scart
Sets the type of video signal to be used on the TV-SCART connector.
The RGB option guarantees high colour accuracy and picture
sharpness by transmitting the red, green and blue colour channels
separately. If the device connected does not support “RGB” output,
select “CVBS”.
Aspect Ratio
If your TV set has a 16:9 aspect ratio screen, select “16:9”. For 4:3
screens you can choose the “4:3” setting. Or select “Auto” to have
the system set the aspect ratio automatically.
Display Format
Select the desired display format.
Ignore Select this option if your TV set converts the aspect
ratio automatically.
Pan & Scan If you have a 4:3 TV set, any 16:9 programmes
appear without the typical black strips at the top
and bottom of the picture. This enlarges the overall
picture; however, the left and right edges of the
picture are not shown.
Letter Box A 4:3 TV set displays the entire picture, but black
strips appear at the top and bottom when
programmes broadcast in 16:9 format are
received.
Video Format
You can optimise the picture resolution for HDMI output here.
Please note that the picture may disappear when you switch the
resolution. For optimum resolution on a modern flat-screen display
we recommend using the 1080P or 720P setting. You can also
choose “Auto” (automatic adjustment to the TV set).
AC3
Specify which port should output the Dolby Digital/AC audio
signals. If you select “Off”, the Dolby Digital/AC audio output is
disabled. Select “SPDIF” to output digital sound via the SPDIF
terminal or select “SPDIF + HDMI” to output it via the SPDIF and
HDMI terminals.