Electrolux Choppy 95387831900 - Manual (Page 8)

18
ENGLAND
M
L
MAINTENANCE
All maintenance, service and cleaning work must be carried out only after the engine has stopped and cooled off. The following operations may be carried out by
the user himself. All other maintenance, service and repair works must be carried out by an authorized dealer.
In the event of using this ride-on lawnmower under extreme conditions and very high temperatures, check more often.
Pb
Pb
The user is legally obliged to take the used batteries to special collection
points or to return them to the retailer.
Those batteries marked with a “crossed out waste disposal bin” and
bearing the chemical symbol Pb (battery containing lead) are not to
be disposed in domestic waste bins.
BATTERY DISPOSAL
BATTERY
Remove the battery during storage!
The ride-on lawnmower can be fitted with various types of battery (see battery sheet for
instructions and use).
BATTERY CONNECTION
1. Open the engine cover (Fig.G)
2. Insert the battery (as illustrated in the relative instruction sheet)
3. Connect the red wire to the positive pole and the black wire to the negative pole
4. Replace the cover after connection.
Recharge the battery only in a dry room.
IMPORTANT! Protect the contacts from dirt, damp and moisture.
DO NOT SPRAY WITH WATER!
OIL LEVEL CHECK
You can check the motor oil level with the dip stick placed in the oil filler tank cap.
The oil level must be between “MAX.” and “MIN.” notches.
OIL CHANGE (starts at page 89)
Used oil can be removed from the oil tank mouth by means of an adapter
(16).
Undertake the operations according to the sequence indicated in Fig. L. Once
done repeat the same operations in reverse order being sure to close connection
(16), replace the cap and remove the tube used for the exhaust oil.
Used oil must not be drained into the sewer system or waterworks. In
order to prevent any pollution to the water-table.
Most garages have used oil deposits, or use the authorized deposits
according to your local authority regulations.
AIR FILTER AND SPARK PLUG
Please follow the engine manufacturers operating instructions enclosed with this ride-
on lawnmower and the fault finding guide.
Always use only original spares!
Should you not have the necessary tools to undertake this operation, take the
ride-on lawnmower to an authorized dealer for blade sharpening or replacement.
Remove the ignition key and always wear protective gloves when you replace the
blade.
1. Release the blade. Fit a new blade or re-sharpen the old one and re-fit.
For safety reasons the blade should only be re-sharpened
by an Authorsied Service Dealer.
BLADE SHARPENING AND REPLACEMENT (starts at page 89)
PRIOR T
O
ST
ORING
EVER
Y 25 OPERA
TING HOURS
AFTER FIRST 5 HOURS AFTER USING EACH TIME A
T
THE BEGINNING OF
EVER
Y SEASON
OFTEN MONTHL
Y
EVER
Y 25 OPERA
TING HOURS
EVER
Y 25 OPERA
TING HOURS
Engine check ■ ■ ■
Oil change ■ ■
Filter cleaning ■
Spark plug checke ■ ■
Air filter replacement ■
Air duct cleaning ■
Switch check ■
Battery and terminal cleaning ■
Brake check ■ ■
Tyre pressure check ■ ■ ■
Blade sharpening or replacement ■
Loose part check ■ ■
Mower cleaning ■ ■