Silvercrest SSM 175 B2 - Manual (Page 40)

38 GB
1. Pull out the mains plug7.
2. If necessary, pull the blender jug6 anti-
clockwise and pull it down and off the
blade assembly4.
3. Rotate the motor unit1 right to the top
until it locks into place in this position.
4. Figure D: turn the rim of the blade as-
sembly4 in a clockwise direction until
the arrow symbol shows to the opened
lock13 and pull it up and off the mo-
tor unit1.
5. Clean the blade assembly with warm
water and a little detergent.
6. Let the blade assembly dry completely.
7. Place the blade assembly4 on the motor
unit1. The arrow symbol shows to the
opened lock13.
8. Turn the blade assembly until the arrow
symbol shows to the closed lock. The
blade assembly is now correctly mount-
ed again.
8. Storage
DANGER for children! Keep the
device out of the reach of children.
DANGER! In order to avoid accidents, the
mains plug7 must never be connected to a
wall socket while in storage.
• Select a location where neither high
temperatures nor moisture can affect the
device.
9. Disposal
The symbol showing a wheel-
ie bin crossed through indi-
cates that the product requires
separate refuse collection in
the European Union. This ap-
plies to the product and all ac-
cessories marked with this symbol. Products
identified with this symbol may not be dis-
carded with normal household waste, but
must be taken to a collection point for recy-
cling electric and electronic appliances. Recy-
cling helps to reduce the consumption of raw
materials and protect the environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.
10. Trouble-shooting
If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock! Do not attempt to repair the
device yourself under any circum-
stances.
Fault
Possible causes /
Action
No function
• Has the device been
connected to the pow-
er supply?
• Check the connection.
• Is the blade assem-
bly4 mounted proper-
ly?
• Has the blender jug6
been engaged proper-
ly?
Blade assem-
bly4 is turning
with difficulty or
not at all • Switch off immediate-
ly, pull out mains
plug7 and check:
Blockage in the vessel?
Liquids are
running out
• Is the quantity of ingre-
dients filled into the
blender jug too large?
GB_103371_Smoothie_Mixer.fm Seite 38 Dienstag, 25. November 2014 6:46 18