Eurotech Appliances WL1000 - Manual (Page 23)

WL1000 User Manual 23
The Stylus
Your ZYPAD WL1000 comes with a stylus that you should use to tap or write on the screen.
In all respects, the stylus works in the same way as a pen or mouse.
Figure 4. The stylus
Three basic actions are possible when using the stylus:
1. Tap / Double tap. Lightly touch the screen with the stylus point to select or double tap to
open an item. Lift the stylus after you tap an item. Tapping is equivalent to the click
operation for selecting (double click for opening) an item with the mouse of your computer.
2.
Drag. Place the point of the stylus on the screen and drag an item across the screen without
lifting the stylus until you have completed the desired operation. This operation is equivalent
to dragging an item with the left mouse button pressed and held.
3. Tap and hold. Hold the stylus point on an item for a short time until a menu will be
displayed. This operation is equivalent to the right click on the mouse.
The Stylus Properties
The stylus properties allow you to configure the double tap sensitivity and the screen calibration.
To set the Stylus properties:
1. Tap Start > Setting > Control Panel
2. Double tap on the Stylus icon. You will obtain the following screenshot.
3. You will be able to set the Double-Tap sensitivity.
4. Follow the instructions that are shown.
5. Tap the Calibration tab.
6. The screen you obtain will allow you to calibrate the touch-screen.