Silvercrest SBS 1400 A1 - Manual (Page 20)

20
Maintenance
4.3 Changing the hygienic exhaust
filter
1. Switch off the appliance Zchapter 3.3,
„Switching off and retracting power cord“.
2. Unlatch the exhaust filter cover (Fig. 21/A).
3. Remove the hygienic exhaust filter (Fig. 21/
B).
4. Insert a new hygienic exhaust filter.
( Zchapter 5.1, „Accessories and Spare
Parts“).
5. Attach the exhaust filter cover at the back-
side first (Fig. 22/A).
6. Then press the exhaust filter cover firmly
down (Fig. 22/B) until you feel and hear it
snap into place.
4.4 Changing the motor protection
filter
1. Switch off the vacuum cleaner and remove
the dust filter bag as described in Zchapter
4.1, „Changing the dust filter bag“, steps 1
to 4.
2. Remove the filter holder with the motor pro-
tection filter (Fig. 23).
3. Remove the motor protection filter from the
filter holder over a dustbin (Fig. 24/A).
„ If the motor protection filter is slightly dirty:
- Beat the dust out of the motor protection
filter over a dustbin (Fig. 24/B).
„ If the motor protection filter is very dirty:
- Replace the used motor protection filter
by a new one. If the new motor protection
filter is too large, lay the the old filter onto
the new filter mat to be cut. Mark the con-
tours and cut the new filter down to size
with a pair of scissors.
4. Clean the filter holder.
5. Insert the filter holder complete with filter in-
to its bracket from above (Fig. 25).
6. Replace the dust filter bag and close the
dust compartment cover. The cover snaps
into place audibly.
4.5 Cleaning the housing
„ Clean the outside of the housing using a
slightly damp cloth only.
NOTE:
Make sure that that the hygienic exhaust fil-
ter is always properly in its position, other-
wise the exhaust air will not be sufficiently fil-
tered.
21
22
23
24 WARNING:
Danger of injury! Always switch off the appli-
ance and disconnect it from the mains before
cleaning it
Zchapter 3.3, „Switching off and
retracting power cord“. Otherwise the
machine might start up and parts of your
body, hair or pieces of clothing might be
sucked in.
ATTENTION:
Do not use cleaning or scouring agents or
alcohol, as these might damage the appli-
ance's housing.
25
SBS 1400 A1_LB5.book Seite 20 Montag, 13. September 2010 6:24 18