Edelbrock 1115 User Manual
Page 2

Rev. A-2/12 - CP/mc
©2012 Edelbrock LLC
Brochure #63-0351
Page 2
Edelbrock LLC • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628
FIGURE 1 - CYLINDER HEAD FASTENER TORQUE SEQUENCE
•
Torque to 55 ft./lbs.
Torque in 3 steps: 20, 40, 55 ft./lbs
•
Re-torque required after initial warm-up and cool-down
- Re-torque
after
each of three (3) hot-cold cycles for
normally aspirated engines
- Re-torque
after
each of five (5) hot-cold cycles for
forced induction (blown) engines
Installation is the same as for stock, except for torque values and sealants. Please note specifications below:
NOTE: It is the customer’s responsibility to check valve to cylinder head clearance prior to final assembly.
Failure to do so could result in serious engine damage.
INSTALLATION