Edelbrock 15005 User Manual

Edelbrock For the car

Catalog #15005

Brochure #63-0245

INTAKE MANIFOLD GASKET

(For Honda D16Y8 Engines)

Catalog #15005

INSTALLATION INSTRUCTIONS

PLEASE study these instructions carefully before installing your new Edelbrock Intake Manifold Gasket. If you have any
questions or problems, do not hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-
Friday, Pacific Standard Time or via e-mail at: [email protected]. Please fill out and mail your warranty card.

Installation Procedure

KIT CONTENTS

Qty.

Description

Intake Manifold Gasket

• Description: This is a replacement intake manifold gasket, which is supplied in the catalog #1500 turbo kit, as well as

the intake manifold kits, #4754 & #4756.

Edelbrock Corporation

2700 California St.

Torrance, CA 90503

Tech Line: 1-800-416-8628

Office: (310) 781-2222

E-Mail: [email protected]

1. Remove the intake manifold as shown in your instructions for part #1500, #4754, or #4756.
2. Clean all gasket mating surfaces. Stuff paper towels into the open intake ports before cleaning to prevent any debris from

entering the engine.

3. Re-install the intake manifold as shown in the #1500 or #4756 instructions, using the new gasket. If your vehicle was not

equipped with air injection, trim the top edge of the gasket

(See. Fig. 1)

4. Torque all intake manifold bolts to 17 ft/lbs., following the sequence below

(See Fig. 2)

Torque all bolts to 17 ft./lbs

Fig. 2

Fig. 1

Cut along dashed lines