Silvercrest TWINTALKER 4810 User Manual

Page 15

Twintalker 4810

ENGLISH

13.10.3 Scanning for a DCS code

Once there is a transmission on the channel, the DCS code (if used) will be detected and
displayed.

13.11 Call Tones

A call tone alerts others that you want to start talking.

13.11.1 Setting the Call Tone
The Twintalker 4810 has 15 call tones.

13.11.2 Sending a call Tone
Press the

button

briefly. The call tone will be transmitted on the set channel.

13.12 Roger Beep On/Off

After the

-button is released, the unit will send out a roger beep to confirm that you have

stopped talking.

To set the Roger Beep.
• Press the

- button

nine times. ‘rO’ will be displayed.

• Press

to enable (ON) or

to disable the Roger-Beep (OF).

• Press the PTT - button

to confirm your selection and return to the

standby mode.

•

Press the

-button

seven times : "SC" and "DCS 00"

flashes on the display for the selected radio channel.

•

Press the

-button

or the

-button

to start the

DCS scan.

•

Press the

- button

eight times, “CA” is displayed

and the current call tone is flashing.

•

Press the

- button

or the

- button

to change to

another Call Tone.

•

Press the PTT - button

to confirm and return to stand-by

mode.

If you press the PTT button

while listening to a found DCS code, the

PMR will go back in stand-by mode on the channel with the DCS code.

PTT