Livarno LED Tube Light - Manual (Page 15)

15 GB
twin circuit before conversion
Tadem circuitry cannot be
converted with LED tubes
Ballast
Ballast
230 V∼
230 V∼
Fluorescent tube
LED tube
110–130 V Series starting electrode
Blind starting electrode
110–130 V Series starting electrode
Blind starting electrode
Fluorescent tube
LED tube
Installation
Remove the fuse or switch off the circuit
breaker in the fuse box before installation.
Set the light switch to the Off/0 position.
Remove the fluorescent tube 2 .
Remove the starting electrode 3 .
Insert the LED blind starting electrode 4 .
Insert the LED tube 5 .
Reinsert the fuse or switch on the circuit breaker
in the fuse box.
Set the light switch to the On/I position.
Disposal
The package and packaging materials
consist entirely of environmentally
friendly materials. They can be disposed
of in local recycling containers.
The icon showing the crossed out
wheelie bin means within the European
Union the product must be disposed of
through separate refuse collection. This applies to
the product and to all components bearing this
symbol. Do not dispose of products bearing this
symbol in your normal household waste, but
instead they must be taken for recycling to a collec-
tion site for electrical and electronic appliances.
Recycling helps to reduce the consumption of raw
materials and protects the environment. Do not
dispose of in the household waste.
Information
Warranty
You receive a 36 month warranty on this product,
valid from the date of purchase. The appliance has
been carefully produced under strict quality con-
trol. Within the warranty period we shall rectify
without charge all material and manufacturing
defects. In the event of a defect arising during the
warranty period, please send the device to the
listed Service Centre address, making reference to
the following article number: 0507-010L. Damage
caused by improper handling, non-observance of
the operating instructions or unauthorised interfer-
ence are excluded from the warranty. The perfor-
mance of services under the warranty does not
extend or renew the warranty period.
Declaration of Conformity
This product fulfils the requirements of the applicable
European and national directives (Electromagnetic
Compatibility 2004/108/EC, Low Voltage Directive
2006/95/EC, Ecodesign Directive 2009/125/EC,
RoHS Directive 2011/65/EU). Conformity has
been demonstrated. The relevant declarations and
documents are held by the manufacturer.
Manufacturer / Service
Briloner Leuchten GmbH
Im Kissen 2,
59929 Brilon,
Germany
Tel.: +49 (0) 29 61 / 97 12–0
Fax: +49 (0) 29 61 / 97 12–199
E-mail: [email protected]
www.briloner.de
IAN 31724
Installation notices / Installation / Disposal / Information