Livarno LED Tube Light - Manual (Page 13)

13 GB
LED Tube Light
Introduction
Congratulations on your new product.
You have selected a high quality prod-
uct. Please be sure to carefully read the
complete operating instructions. Fold out the page
with the illustrations. These instructions are part of
the product and contain important information on
setup and handling. Always follow all safety in-
structions. Before using this product for the first time
verify the correct voltage and that all parts are
properly installed. Should you have any questions
or you are unsure about operating the product,
please contact the dealer or service centre. Please
keep these instructions in a safe place and pass
them on third parties as applicable.
Intended use
The LED tubes are suitable for indoor use at an
ambient temperature of -20 °C to +40 °C. Only
use the LED tubes outdoors with an IP-certified
lamp. The LED tubes are suitable to directly replace
fluorescent tubes with starting electrodes (single- or
twin circuit). Not suitable for electronic ballasts.
Scope of delivery
Check immediately after unpacking that the parts
are complete and that the product is in proper
condition.
1 LED T8 tube, model 0507-010L
1 Blind starting electrode
1 Instructions for assembly and use
Parts description
1 ON / OFF switch
2 Fluorescent tube
3 Starting electrode
4 LED blind starting electrode
5 LED tube
Technical Data
Item no.: 0507–010L
Wattage:
10 W
Lumens: 850 lm
Kelvin: 4000 K
Ra: ≥ 80
Socket: G13
V:
220–240 V∼
Hz: 50 Hz
mA: 50 mA
Beam angle: 150°
T(h): 25,000 h
ON / OFF: 15,000 x
Quick light: <1s = 60 % light
Hg: 0 mg
Dimensions: L 600 mm; D 30 mm
Ambient temperature: -20 °C to +40 °C
Non-dimmable
Safety
Safety information
Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or personal
injury due to improper handling or failure to
comply with the safety instructions!
Cut off the current before installation to prevent
electric shock. Check local electrical requirements
and ordinances.
Never use the LED tube if any damage is
detected. A damaged LED tube means danger
of death from electric shock.
Introduction / Safety