Livarno Z30347C - Manual (Page 5)

5 GB
Safety Information
packaging materials. Danger of suffocation.
Keep out of the reach of children.
J This device is not a toy and should not be
played by children. Children are not able to
understand the dangers that can occur when
handling this device.
WarNINg! rISK OF FaTaL INJUrY!
During installation keep children away from the
area in which you are working. The scope of
supply includes a number of screws and other
small parts. These may prove lifethreating if
swallowed or inhaled.
J Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited must
never be allowed to use the device without
supervision or instruction by a person responsible
for their safety. Children must never be allowed
to play with the device.
J CaUTION! DaNgEr OF EX-
PLOSION! Do not operate the lamp
in potentially explosive environments
in which there are inflammable vapours, gases
or dusts.
J
0.5 m
FIrE HaZarD! Fit the light so that
it is at least 0.5 m away from the
material illuminated. Fire can result
from the development of too much heat.
J
F
The light can be installed on all
normally flammable surfaces.
J This lamp is only intended for use
indoors.
J CaUTION! rISK OF INJUrY!
Broken glass must be replaced before
any further use is made of the lamp.
Danger to life by electric shock
J Electrical installation must be performed by a
qualified electrician or a person authorised to
perform electrical installations.
J Every time before connecting the lamp the mains,
check it and the mains lead for damage. Never
use your light if you find it is damaged in any way.
J Before installation, remove the fuse for this
circuit or switch off at the circuit breaker
(0 setting) in the fuse box.
J Make sure before installing the light that the
mains voltage at the place of installation complies
with the operating voltage of the light
(230 V ~) and that the wire cross-section of the
supply cable is at least 1 mm 2 . Do not install
the light if this is not the case.
J Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric shock.
avoiding fire hazards
and risk of injury
m CaUTION! rISK OF INJUrY! Check the
lamps and light immediately on unpacking for
signs of damage. Do not install the light if you
discover any damage. In the event of damage,
please contact the service office for replacement.
WarNINg! rISK OF ELECTrIC SHOCK!
rISK OF DaMagE TO PrOPErTY! rISK
OF INJUrY! Make sure that you do not hit
electrical cables, gas or water pipes when you
drill into the wall / ceiling. You may have to
check with a cable locator before drilling into
a wall / ceiling.
CaUTION! rISK OF BUrNS! Make sure that
the light is switched off and has cooled down
for at least 10 min. before you touch it. Lamps
can become very hot.
Correct procedure
J Before wall / ceiling mounting, check that the
wall or ceiling in question is suitable for bearing
the weight of the lamp. You may have to consult
an expert.
J Before wall / ceiling installation, find out what
the most suitable installation material for your
wall / ceiling is.
J We have included assembly material for wall
or ceiling mounting suitable for the usual firm
masonry.