Livarno Z32102A - Manual (Page 36)

36 GB/MT
Replace the rechargeable battery 9 if the light output does not improve after
charging (see Fig. E).
Installing the light
For optimal results, please the LED solar light in a location where the solar cell 5
is exposed to direct sunlight for as long as possible.
Do not place the LED solar light under shrubs, trees, awnings, etc. This will reduce
the incidence of sunlight.
Position the LED solar light so the solar cell is not covered or shaded.
Make sure the solar cell is not impacted by other light sources, e.g. yard- or street
lighting, or the light will not switch on at twilight.
In low light the light will automatically switch on, and automatically switch off in
normal ambient light.
Note when using as accent lighting (with ground spike):
Push the assembled LED solar light far enough into the ground (grass, flower bed)
so it is stable. Make sure it is firmly placed.
Do not use force during assembly or setup, e.g. hammer blows. This damages the
product.
63018_livx_A_LED-Solarleuchte_content_ES.indd 36 21.05.14 15:36