Livarno Z32102A - Manual (Page 35)

35 GB/MT
Now remove the insulating strip 10 located between the battery 9 and the
compartment pole (see Fig. G).
Then install all components in the reverse order. Be careful not to damage the cable.
Set the ON/OFF switch to the „ON“ position.
Your product is now ready for use.
Before first use
Note: The built-in LED lamp features a flicker function to simulate the natural flickering
of candlelight. This is not a defect!
Charging
Note: The battery built into the LED solar light is charged at the time of delivery.
However, it may have lost charge during transport from the manufacturer to the retail
location. Therefore please charge the battery before the first use. The first charging will
take at least one day in good sunlight during the summer.
Set the ON/ OFF switch 6 to the „ON“ position (see Fig. D).
Note: In constant sunlight (depending on the season) drained batteries should
take two to ten days to charge.
63018_livx_A_LED-Solarleuchte_content_ES.indd 35 21.05.14 15:36