Envision Peripherals EN7600 User Manual
Page 16
15
ERROR MESSAGE & POSSIBLE SOLUTION
CABLE NOT CONNECTED :
1. Check that the signal-cable is properly connected , If the connector is
loose, tighten the connector’s screws.
2. Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORTED :
Your computer has been set to unsuitable display mode ,set the computer to
display mode given in the following table (See page 17).
See also other documents in the category Envision Peripherals Monitors:
- EN9250 (25 pages)
- EN-980e (15 pages)
- EN7400e (19 pages)
- EN-780e (15 pages)
- G912WA2 (1 page)
- EN9110 (28 pages)
- EN-775e (15 pages)
- G22LWK (1 page)
- EN-780e 17 (17 pages)
- EN-5200e (21 pages)
- EN7410 (25 pages)
- EN-770e (15 pages)
- EN-7100s (19 pages)
- EN9410e (25 pages)
- AOC 9KLR (15 pages)
- H190L (73 pages)
- EN-5100e (18 pages)
- G218a1 (46 pages)
- G2016WA2 (12 pages)
- EFT920 (14 pages)
- EN-8500 (32 pages)
- Envision Professional G918w1 (13 pages)
- EN-8100e (20 pages)
- EN-7100e (20 pages)
- E218C1 (1 page)
- EN7220 (25 pages)
- LCD (11 pages)
- Envision H1781 (14 pages)
- EN7410e (25 pages)
- EN-985e (15 pages)
- H193WK (20 pages)
- LM914 (28 pages)
- EN9600 (20 pages)
- EN9410 (25 pages)
- Envision H170L (37 pages)
- H712a (1 page)