Livarno LLR 58 A1 - Manual (Page 3)

3
The light does not contain any parts
that require servicing. Never open the
housing of the light. Inside the casing
there is a glass tube. Ensure that the
light is not subjected to excessive
vibrations. If the glass tube breaks,
the light is unrepairable and must be
disposed of. There is a risk of injury if
the glass body is broken!
Do not hang any objects on the light.
The casing is not designed to carry
loads. Do not allow any flammable
materials next to or behind the light.
This can damage the lamp and there
is risk of fire.
Intended use
This light is not intended for commercial
use. Install this light only in enclosed
rooms. Assembly must be carried out
properly. The light can be fixed to a wall
using the supplied assembly clips. The
supplied base permits the light to be used
in a standing position.
The light is a fluorescent tube and not
designed to be dimmed.
This device meets all relevant norms and
standards in conjunction with CE
conformity. Compliance with these norms
is no longer guaranteed if the device is
altered in ways not sanctioned by the
manufacturer.
Description
The parts shown in the illustration are as
follows:
[1] Assembly
clips (2 pieces)
[2] Fixing screws, 32 mm for assembly
clips (2 pieces)
[3] Rawlplugs (2 pieces)
[4] Fixing screws, 21 mm for light stand
(2 pieces)
[5] Light stand (upper section)
[6] Light stand (lower section)
[7] Tube holder for light stand
[8] On/Off button
The illustration is not to scale.
Technical Data
Operating voltage: 230 V~ 50 Hz
Illuminant T8, 58W: Fluorescent tube
Permissible
ambient temperature: max. 30 °C
Safety Class:
II
Getting Started
Selecting a Site
You can attach the light to a wall or ceiling.
Using the stand, you can also use the light
in an upright position. When choosing the
site where the light is to be installed, bear in
mind the following:
 Ensure that the mains plug is
disconnected from the socket outlet in
case the light has been switched on
before.
 There should be no flammable material
near the installation location (e.g.
curtains, streamers or similar).
 There should be an available socket
outlet near the installation location. The
socket outlet must be easily accessible
so that the mains cable of the light can
be pulled out immediately in a
dangerous situation.
 Ensure that the surface that the light is
to be attached to is stable. If the lamp
tips over or falls new dangers may
arise.