Emerson Radio AV400 - Manual (Page 22)

21
Display Indicators
Tuning
Manually
1. Press TUNER to select tuner mode, the display will change to show the current band and frequency.
2. Press or / on the Front Panel or use the remote’s numeric keys to change the
frequency.
Automatic tuning
1. Press TUNER to select tuner mode.
2. After two seconds the display will change to show the current band and frequency.
3. Press and hold
or for more than one second to activate auto tuning mode. When a
station is reached, auto tuning will stop.
Tuning to a weak FM stations
1. Press
to tune in a weak FM station manually.
MHz
2. Press AUDIO/FM ST on the remote control to switch to Mono mode. This will normally improve the
reception, but the sound will no longer be in stereo.
Preset Stations
When a preset station is selected, the preset number will appear next to the frequency on the display.
Selecting Preset Stations
1. In tuner mode, press TUNER to switch between AM and FM band if necessary.
2. Press OK, then use the remote’s numeric keys or to select desired preset station.
Storing Preset Stations
The unit can store up to 20 stations in the FM and AM wavebands respectively.
1. In tuner mode, press TUNER to switch between AM and FM band.
Radio
Hz M
ST
K
M
Hz
Hz
AM Frequency Indicator
FM Frequency Indicator
Stereo Indicator
MHz
Hz M
Storing Preset Stations
The unit can store up to 20 stations in the FM and AM wavebands respectively.
1. In tuner mode, press TUNER to switch between AM and FM band.
Hz M