beautypg.com

Function, Installation – Livarno 108340-14-01/108340-14-02/108340-14-03 User Manual

Page 9

background image

9

GB

CAUTION! EXPLOSION
HAZARD!

Never throw batteries into fire or water!

Do not exert mechanical strain on batteries!

Do not use disposable batteries.

Never short-circuit or open rechargeable
batteries.

Risk of equipment damage

Only use the battery type specified!

When inserting the battery ensure the correct
polarity! This is shown inside the battery
compartment!

If necessary, clean the battery and device
contacts before inserting the battery!

Function

Solar cell
The solar cell

6

converts energy from sunlight

into electricity. Using this electricity, the installed
batteries

10

are charged in the battery com-

partment

9

.

These batteries store the electricity fed by the
solar cell. Fully charged batteries deliver light
for approximately 6 hours, when the ON / OFF
switch

11

is in the „ON“ position.

In summer, completely drained batteries take about
1 to 2 days to fully recharge in good sunlight.

Sensor
During periods of twilight or darkness, the sen-
sor

7

registers a change in the angle of heat

radiation, triggered by people passing by the
sensor (Diagram I). When the sensor recognises
a moving person the light is switched on. The
light goes off after approx. 1 minute, after the
last movement was recognised.

Installation

When selecting the mounting location, pay
attention to the following:

1. The solar cell

6

requires direct sunlight when

possible. Ideally, the solar cell surface will be
directed to the south. The horizontal direction