Livarno 1250-022L - Manual (Page 7)

7 GB
Start-up Safety advice
Start-up
Mounting the light
Position the washers 8 on the stand tubes 7
(see fig. A).
Remove the transportation lock 9 between
the two stand tubes 7 (see fig. B).
Remove the protective foil from the decorative
layer and put it on the metal layer of the base 6 .
(Side protection foil, front side)
Carefully lead the cable through the
hole in the base 6 . Please be aware that the
pre-assembled cable tie 10 may not be thrown
away.
Insert the stand tubes of the standing lamp 7
into the into the pre-mounted holes in the base
6 . Ensure that the cable duct is pointing to-
wards the rear of the lamp (see fig. A) (front
side - position dimmer switch, back side - cable
outlet).
Draw the cable tie 10 through the holes of the
mounting plate 11 (see fig. C).
Push the mounting plate 11 onto the stand tubes
7 . Ensure that the curvature of the mounting
plate 11 is pointing outwards. Ensure that the
cable tie 10 is pointing to the power cable side.
Place the serrated lock washers 13 at the un-
derside of the base 6 onto the stand tubes 7 .
Route the power cables through the nuts 14 .
Ensure that you first route the round plug-in
connector through the nut
14 and then the small
rectangular plug-in connector.
Using the open spanner 12 , tighten the nuts 14
in a clockwise direction onto the stand tubes 7
to fix the standing lamp to the base 6
(see fig. D).
Now join the small rectangular plug-in connectors
together leading from the two stand tubes 7 .
Connect the round plug-in connectors with the
power cable of the base (see fig. E).
Put the cable in the notch provided in the
base 6 .
Fix the cable with cable ties 10 . Ensure that the
cables lie in the designated recess in the base 6
and cannot be squeezed (see fig. F).
Adhere the felt cover 15 to the base 6
(see fig. G).
Connect the mains cable of the base 6 with
the mains plug-in adaptor 16 (see fig. H).
Plug the mains plug into a socket that has been
professionally installed.
Your light is now ready for operation.
Switching the lamp on / off
Switch the ceiling floodlight on or off by turning
the ON / OFF rotary switch 5 to the left
(see fig. I).
Use the ON / OFF switch 3 to switch the read-
ing lamp on and off.
Dimming the ceiling floodlight
Dim the light of the ceiling floodlight by turning
the ON / OFF rotary switch 5 to the right.
Note: The light is always set at the lowest
dimming level when it is switched on.
Adjusting the lamp (see fig. J)
Loosen the height adjustment screw 17 and set
the required height for the ceiling floodlight.
You can adjust the height of the ceiling floodlight
between 1.10 m and 1.80 m.
Re-tighten the height adjustment screw 17 in or-
der to fix the ceiling floodlight at the required
height.
Bend the flexible arm 2 of the reading lamp
in the required direction.
Do not rotate the flexible arm 2 of the reading
lamp completely. Otherwise the mains cable
inside the lamp could be damaged.
The up-light is hinged and pivoted. Tilt the up-
light to the desired angle.