Livarno 1250-022L - Manual (Page 6)

6 GB
Start-up Safety advice
Safety advice
Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or personal
injury due to improper handling or failure to comply
with the safety instructions!
Avoid the risk of fatal injury
from electric shock
Check the light for damage every time before
you use it. Never use the light if it shows any
signs of damage.
CAUTION! A damaged light means danger of
death from electric shock! In the event of damage,
repairs or other problems with the light please
contact the service centre or a qualified electri-
cian.
For the prevention of hazards, a damaged flexible
lead of this lamp may only be exchanged by the
manufacturer, his service representative or by an
equally qualified specialist!
Ensure before use that the available mains voltage
is the same as the voltage required for operating
the lamp (200–240 V∼).
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
This lamp is only suitable for use in living areas
(not damp rooms) and may only be used in ac-
cordance with its design.
This lamp may only be used with the plug-in
adapter included in the delivery.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Prevent fire and
injury hazards
CAUTION! RISK OF INJURY! Check every
illuminant for damage immediately upon un-
packing. Do not install the light if the illuminants
are defective. In this case contact the service
centre for a replacement.
CAUTION! DANGER OF BURN INJURIES!
Ensure that the light has been switched off and
has cooled before touching it, to avoid burn in-
juries. Lamps develop intense heat in the area
of the lamp head
Do not allow any objects to cover the light.
Excessive heat can result in a fire.
Never leave the light operating unattended.
Do not leave the light or packaging material ly-
ing unattended. Plastic film or bags, plastic parts
etc. can turn into dangerous toys for children.
The type of LED illuminant included is not suitable
for dimmer or electronic switches
This product does not contain any parts that can
be serviced by the user. The LED illuminant cannot
be exchanged.
Safe working
Install the light so that it is protected from mois-
ture and dirt.
Carefully prepare the installation and allow suf-
ficient time. Organise all parts and any necessary
additional tools or materials before starting so
they are easy to reach.
Always be attentive when working! Always pay
attention to what you are doing and act with
common sense. Never install the light if you are
having difficulty concentrating or do not feel
well.