Livarno Z31228 - Manual (Page 11)

11 GB
Batteries must not be disposed
of in the normal domestic waste!
All end users are legally re-
quired to dispose of batteries
properly.
Mounting (see Fig. A)
Note: Clean the surface well
onto which you wish to mount the
product. The surface must be clean,
free from grease and dry. Other-
wise the stickiness of the double-
sided adhesive tape
6 might be
limited.
Note: Before use, check on a
hidden area of the surface, whether
the adhesive can cause damage.
Note: you will need a drill for
installation.
CAUTION! RISK OF
INJURY! Please refer to the
operating instructions of your drill.
CAUTION! Be sure not to
damage lines inside the wall.
Remove the protective film from
the adhesive on the back of
the light strips
3 and attach
the LED strip at the desired point.
Attach the LED driver 7
using the included double-
sided adhesive tape
6 or
the included screws 10 .
Connect the transformer 5
to the mains plug 4 , the LED
driver and the LED strip.
Note: Ensure when connect-
ing the LED driver
7 with
the LED strip that you align
the +RGB markings on the
LED driver with the +RGB
marking of LED strip.
Please ensure that the mains
plug of the transformer is al-
ways accessible.
Insert the mains plug into the
mains socket before you turn
on the product.
Connecting the 2 LED strips
(see Fig B):
Note: A maximum of two 5 m
LED strips can be connected with
the eight point plug
13 and oper-
ated with one LED driver and one
transformer. Otherwise there is
the risk of overloading the com-
ponents and fire.